Get a Chief’s Shop hat!
  • Enter your email address to subscribe to this blog and receive notifications of new posts by email. If you receive a message that your e-mail address is invalid, please visit my blog page and sign up in the area on the right-hand side of the page.

  • Hall Bench

    Place this bench in a hall (as its name implies), foyer, mudroom, or at the end of a bed.

    The Chief’s Shop Hall Bench project looks a bit more complicated than it really is. The legs do require a bit of patience, but if you are scared to cut the curves along the edge and at the bottom, you can simply skip those steps - the ends are 15-degree angles.

    My usual tool suspects are needed to complete it – table saw, miter saw, jig saw, drill driver, and Kreg Jig. It’s all 2x4s unless you decide to cut the Leg Stretchers from 2x2s rather than ripping them from the 2x4s.

    Download this free woodworking plan pdf file by clicking on the image at left.

    (C) Chris Hill/Chief’s Shop 2009-2014
    Visit Chris Hill's profile on Pinterest.